Vertical Tillage Attachment
This attachment allows you to convert your Wil-Rich chisel plow into a vertical tillage tool - perfect for managing today's high residue farming. The attachment uses wavy coulters that can be attached to the chisel plow shank in place of points or sweeps. The down pressure on each shank stays uniform across the entire chisel plow. The shanks also act as a scraper for the coulters, so no extra equipment is needed to till wet and sticky soils. 7-10 HP per foot is recommended because of the high speed required.
Why use Vertical Tillage?
Aerate and warm spring soil for earlier planting in cold and wet conditions. - Mixes residue with soil to control erosion.
- High Speed: 8-12 mph equals less time preparing your field.
- Conditions soil in high residue before or after fall tillage preparations.
- Designed for heavy trash at high speed.
3-Bar Heavy Duty Coil Tine Harrow
- Five Tine Angle Adjustments
- Five Harrow Height Adjustments
- 5/8" Diameter Wire
- 26" Long Tooth
- Spring Loaded Harrow Arms
Optional finishing attachment is available for leveling soil and residue distribution.
Use the 5800 Chisel Plow with chisel point for fall tillage preparation, or remove the points and replace with the Vertical Tillage Attachment. One tool with multiple purposes.
Note: Fits Wil-Rich models 5810, 5830 and 5850. Vertical Tillage Attachment may not fit on all Chisel Plows. Check with your dealer or factory representative.
